The capacity of an activated carbon to retain a given substance is not only given by its surface area, but also by the proportion of pores whose size is adequate, i.e., a suitable little has a diameter of between one and five times the molecule to be adsorbed.
If this condition is met, the capacity can be between 20% and 50% of its own weight.
Dechlorination consists of a complicated mechanism that can follow different reaction paths in which CA can intervene as a reactant or as a catalyst.
Free chlorine can be added to water in the form of chlorine gas, sodium hypochlorite solution, or calcium hypochlorite tablets (granules). In either case, the chlorine is dissolved in the form of hypochlorous acid (HOCl), a weak acid that tends to partially dissociate.
The distribution between hypochlorous acid and hypochlorite ion depends on the pH and concentration of these species. Both molecular forms are defined as free chlorine.
Both are strong oxidizers which, when added to water, react almost immediately with organic and inorganic impurities and exert a biocidal effect on microorganisms.
The chlorine that reacts and intervenes in this disinfection stage is no longer free and remains combined and is no longer free. Once this stage is completed, it is necessary to eliminate the residual free chlorine by means of granular activated carbon.
When carbon is exposed to free chlorine, reactions take place in which HOCl or OCl- is reduced to chloride ion. This reduction is the result of different possible reaction paths.
Where C* represents activated carbon. C*O and C*O2 are surface oxides, which gradually occupy spaces that, being blocked, no longer participate in the reaction. Some of these oxides are released into solution as CO and CO2. This again leaves available spaces that therefore increase the capacity of the CAG for this reaction.
As for Cl-, it also accumulates on the coal surface during the first moments of operation. As HOCl or OCl- continues to reach the carbon surface, the reaction slows down a bit, and then Cl- begins to be released. This slowdown is due to the poisoning of the coal with surface oxides. This poisoning continues gradually, while the adsorption and dechlorination capacity of the AC decreases.
In the above reactions it can intervene in place of HOCl, with the difference that no H+ is produced. It can be observed that the AC reacts and therefore disappears. If there were no accumulation of surface oxides, the reaction would continue until the complete disappearance of the carbon.
Colors that manifest themselves in liquids are usually large molecules. Therefore, they are adsorbed in large pores, which means that the most suitable carbons to retain them are those with higher macroporosity.
Wood charcoals, especially those of not very hard woods (such as pine) that are chemically activated, are the most macroporous and, therefore, are the most suitable for decolorizing.
The problem with these carbons is that they are not very hard and not very resistant to abrasion, which makes it necessary to apply them in powder form. When the decolorizing coal is required to be granular, the best alternative is usually a lignite coal. It is the mineral coal with the highest macroporosity.
The most common contaminants in well water are usually of low molecular weight and, for these cases, the most suitable carbon is one with high microporosity.
The coals that best meet this condition are, firstly, coconut shell coals and, secondly, bituminous minerals.
When a carbon is chemically activated, it is impractical and unnecessary for the manufacturer to remove all the chemical used from the final product. Therefore, if the chemical was an acid, it will lower the pH of the first few liters of water that come in contact with the coal. The opposite will occur if the chemical used was an alkali.
In the case of a thermally activated carbon (without the presence of chemicals other than water vapor and combustion gases), it increases the pH of the first few liters of water treated with it. This is because all vegetables have significant amounts of sodium, potassium, calcium and other cations that, in the carbonization process, remain in the charcoal in the form of oxides. These oxides become hydroxides when they come into contact with water, dissolve in water and increase its pH.
When the pH of the first few liters of water that come into contact with a carbon does not vary, it may be a pH-adjusted carbon or an ultrapure (soluble-free) carbon.
All gaseous contaminants have molecular diameters less than 2 nm. This means that they adsorb better in micropores. Coconut shell coals have the highest microporosity and are therefore the most widely used in air and gas purification.
There are activated carbons of modified structure, special activated carbon, which are used when a standard activated carbon cannot retain other non-organic compounds.
In recent times different products have become famous that make use of activated charcoal for different types of purposes, in some cases activated charcoal is used for supposedly slimming and even for facial care that could probably be addressed with more appropriate solutions. In this article we are going to review what activated charcoal pills can do for our health.
One of the products that became more famous thanks to social networks were activated charcoal tablets . Many young people mention that they take them to get rid of the famous hangover, others argue that their use has helped them to lose weight, but do these revolutionary activated charcoal pills really work?
Also: Is it advisable to use activated charcoal as a medicine?
Armenian 
English 
Afrikaans 
Albanian 
Amharic 
Arabic 
Azerbaijani